motor control center
英 [ˈməʊtə(r) kənˈtrəʊl ˈsentə(r)]
美 [ˈmoʊtər kənˈtroʊl ˈsentər]
发动机控制中心; 缩写词为MCC
双语例句
- The aging mechanism for motor control center ( MCC) of nuclear plant was analysed.
分析了核电站电动机控制中心（MCC）的老化机理。 - An intelligent motor control center ( MCC) system was designed.
设计了一种智能电动机控制中心系统。 - Review of Motor Control Center
电机控制中心综述 - Design of Open Monitoring and Control Software in Motor Control Center
具有开放性的电动机控制中心监控软件设计 - DCS system has two sets field devices control Units. One sets on the motor control room, the other sets on the center control room.
DCS系统设有两套现场装置控制单元，一套设在电机控制间，一套设在中心控制室。 - The function and technology tendency of intelligent motor control center is analyzed in detail. Then a novel intelligent motor control center structure is described and key technologies of the intelligent motor control center are presented.
在详细分析智能电机控制中心的功能和技术发展趋势的基础上，提出了智能电机控制中心的一种新的结构形式及其研制的关键技术。 - Finally, experiment was done in the motor experiment system whose control center is digital signal processor ( TMS320LF2407), experiment validated DTC's main algorithm.
最后在以DSP（TMS320LF2407）为核心的电机实验平台上做了实验，对其主要算法进行了验证。 - A slip frequency control system of asynchronous motor used DSP as control center is presented, which apply to the electric tourist car.
介绍一种以DSP为控制核心的异步电动机转差频率控制系统在电动游览车中的应用。 - Application of intelligent motor control center system in PTA unit
智能马达控制中心系统在PTA装置的应用 - The multi-motor control system adopted client/ server structure based on controller area network ( CAN) bus, and the virtual instrument became the host unit replacing the motor control center in the development phase to debug and measure each motor control client unit.
采用基于CAN（ControllerAreaNetwork）总线的主从式分布结构，在产品研发过程中虚拟仪器取代电机控制中心成为主节点，完成对各个电机控制单元的调试和测量。 - Combining application experience, the paper introduces the distribution and functions of intelligent motor control center system in PTA unit of chemical factory, and summarizes the advantages and speciality.
结合化工厂PTA装置应用实例，介绍了智能马达控制中心系统的配置、功能，并总结了智能马达控制中心系统的优点与特点。 - The results with integration method are not only close to the actual condition, but also they provide a reference for the motor selection, structure design and control system design. ( 3) Firstly, key components of the turn-milling center are analyzed as lumped masses.
该集成仿真方法不仅接近实际情况，而且为加工中心的电机选择和结构设计以及控制系统的设计提供参考依据。